I doused my Inspiron 6000 with h2o and had drinking water amongst the laminaire with the Liquid crystal display. I attempted all of the things encouraged by Other people, but ultimately I did the exact same factor you did, except I cut the sealing tape and applied new when performed. Mine is now nearly as good as new. Several suggestions. You may need the proper equipment, and endurance. Dont attempt to acquire alongside and not using a good quality 0 and 00 phillips, aluminum foil tape and mylar tape. To scrub the varied levels I used eyeglass cleaner wipes, and adjusted them frequently.
Put up-op I’m persuaded the backlight is ok and thus the inverter is at fault. For around $30 I hope to aquire a replacement. This will be a reasonable Charge for that repair.
Then I carefully taken out the plastic include by inching it up with my fingers. There were two screws close to the bottom on the panel that required to be eradicated, and also a significant voltage plug with white & pink wires that should pull from a circuit board
Can the thing is the taskbar above this blank place to the monitor or it addresses the taskbar with Element of the image?
In spite of everything latches here are opened you ought to be in a position to individual the monitor into 3 items: metallic frame, Liquid crystal display and background (unsure about proper complex title).
To fix each difficulties I had click to open up the LCD display. This was my initial encounter on opening a notebook display screen. I used to be quite self-assured since I didn’t seriously care if I split the display, I just planned to know if it’s feasible to fix it.
plastic include likewise. I changed everything, and now my Exhibit performs flawlessly. When you've got the same Display screen difficulty
At this point it’s tough to explain to which a single is creating the issue. Your notebook labored good for two days Once you changed the inverter board, so I'd consider changing the inverter board all over again. It’s doable you bought a defective inverter board.
I see that, on the shots (and in my own laptop) You can find that white tape with certain instructions not to touch it. Even so, it would appear that you site are, the truth is, touching it any time you’re displaying in which to get rid of the screws to the facet of the screen.
I think they place “Don't contact” Guidelines simply because you can find facts cables connecting the circuit board Along with the Liquid crystal display and they're Positioned suitable under the white tape.